Command Reference Guide

254 ● sot sdlc controller 3Com Router 5000 Family and Router 6000 Family
Command Reference
sot sdlc controller
Purpose Use the sot sdlc controller command to configure the SDLC address of a
connected terminal.
Use the undo sot sdlc controller command to remove the SDLC address of a
connected terminal.
Syntax sot sdlc controller sdlc-address
undo sot sdlc controller sdlc-address
Parameters sdlc-address
SDLC address of the terminal. Valid values are 0 to ff
(exclusive).
Default By default, no terminal is specified.
Example Configure the terminal C2.
[Router-Serial0/0/0] sot sdlc controller c2
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description This command allows the router to implement point-to-multipoint transmission in
SDLC mode, sending packets to multiple connected terminals. This command is used
to have an IBM controller or front end processor to communicate with specified
terminals.
Before you can configure the sdlc controller command on the interface, you
must assign the interface to a SOT protocol group. In addition, multiple terminals can
be configured.