Command Reference Guide

250 ● sot gather 3Com Router 5000 Family and Router 6000 Family
Command Reference
sot gather
Purpose Use the sot gather command to assign the serial interface to an existing SOT
protocol group.
Use the undo sot gather command to remove the serial interface from its SOT
protocol group.
Syntax sot gather group-number
undo sot gather group-number
Parameters group-number
Any integer bettween 1 and 255.
Example Assign interface Serial 0/0/0 to SOT protocol group 2.
[Router-Serial0/0/0] sot gather 2
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description You can assign a serial interface to only one SOT protocol group. If this group is
operating in simple SOT mode, the interface will operate in simple SOT mode
providing only point-to-point data transmission. If this group is operating in SDLC
mode, the interface operates in pass-through mode or local acknowledgement mode
providing point to multipoint data transmission.
The configuration of the sot gather group-number command will replace the
original one, if there is any.
When the type of the SOT protocol group changes, from simple to SDLC for example,
the SOT configuration on the interface is removed.
Related Command sot group-set