Command Reference Guide

200 ● ip multicast-policy route-policy 3Com Router 5000 Family and Router 6000 Family
Command Reference
ip multicast-policy route-policy
Purpose Use the ip multicast-policy route-policy command to enable a multicast
policy routing on an interface.
Use the undo ip multicast-policy route-policy command to remove a
multicast policy route applied on the interface.
Syntax ip multicast-policy route-policy policy-name
undo ip multicast-policy route-policy policy-name
Parameters policy-name
Specifies the name of a route-policy, which uniquely
identifies one route-policy.
Default By default, no multicast route policy is enabled.
Example Enable multicast policy routing named map1 on interface Ethernet 2/0/0.
[3Com-Ethernet2/0/0] ip multicast-policy route-policy map1
View This command can be used in the following views:
■ Interface view
Description When multicast policy routing is configured on an interface of a router, all multicast
packets entering the router on the interface will be filtered.
Using this command can enable multicast policy routing defined by the route-policy
named policy-name on an interface.
The filter method is that all policy nodes of the route-policy specified by the policy
routing are tried in the order of the ascending sequence of the numbers. If a packet
meets the if-match conditions specified in a policy node, actions specified by the node
will be performed. If a packet does not meet the if-match conditions specified in a
policy node, the next node will be detected. If a packet does not meet the conditions
of any policy nodes, the packet will return to the normal forwarding flow.
Related Command route-policy