Command Reference Guide

94 ● display detect group 3Com Router 5000 Family and Router 6000 Family
Command Reference
display detect group
Purpose Use the display detect-group command to display configuration information
about a specified detect group or all detect groups.
Syntax display detect-group [ group-number ]
Parameters group-number
Number of the detect group to be displayed. Valid
values are 1 to 100.
Example Display configuration information about detect group 1.
[3Com] display detect-group 1
detect-group 1 :
detect loop time(s): 15
ping wait time(s): 2
detect retry times: 2
detect ip option: and
group state: not detecting
register module num: 0
detect ip number: 1
detect-list ip address next-hop
1 1.1.1.1 1.1.1.5
View This command can be used in the following views:
■ Any view
Table 9 Description on the fields of the display detect-group command
Field Description
detect-group 1 The following configuration information is about detect group 1.
detect loop time(s): 15 The auto detect interval is 15 seconds.
ping wait time(s): 2 The timeout period of a probing attempt is 2 seconds.
detect retry times: 2 The number of probing retries is 2.
detect ip option: and The logical relationship between the addresses in the detect group is
and.
group state: not
detecting
Current state of the detect group is that no probing is going on.
register module num: 0 Count of times the detect group has been referenced.
detect ip number: 1 Number of IP addresses in the detect group.
detect-list Sequence number of an IP address in the detect group.
ip address IP address to be probed.
next-hop Next hop IP address for reaching the IP address to be probed.