Command Reference Guide

156 ● display nat 3Com Router 5000 Family and Router 6000 Family
Command Reference
View This command can be used in the following views:
■ Any view
Description Users can verify if the configuration of address translation is correct according to the
output information after execution of this command. When address translation
connection information is displayed, the parameters of global-addr and inside-addr
can be specified for the
display nat session command simultaneously.
Table 15 Description on the fields of the display nat command
Field Description
Protocol Protocol number. VPN indicates that the entry corresponds to a MPLS
VPN virtual route forwarding instance.
GlobalAddr Port Translated external address (source address) and port (source port).
Note: Since a nat session entry is dynamically generated for packets
sent from the internal network to external networks, the naming and
meaning of the fields is from the perspective of the internal network.
InsideAddr Port Internal address (source address) and port (source port) to be
translated.
DestAddr Destination address of the packet.
Port Destination port of the packet.
status A hexadecimal value indicating the status. When the status is NOPAT,
the value is the special identification of the nat session entry in NOPAT
mode.
Note: The value contains 32 bits, each of which indicates a specific
status attribute of the entry.
TTL Time for which the entry exists, in the format of hh:mm:ss.
Left Time after which the entry expires from now on, in the format of
hh:mm:ss.