Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display ip policy setup ● 149
Command Reference
display ip policy setup
Purpose Use the display ip policy setup command to view the setting information of
policy routings.
Syntax display ip policy setup { local | interface interface-type
interface-number }
Parameters local
Displays the setting information of local policy
routings.
interface
Displays the setting information of interface policy
routings.
interface-type
Interface type.
interface-number
Interface number.
Example Display the configurations of policy routing on the specified interface, regardless of
whether the policy routing is enabled.
<3Com> display ip policy setup interface ethernet 0/0/0
route-policy pr01 permit 0
if-match acl 3101
apply output-interface Serial1/0/0
This command displays the configurations of the policy routing named
pr01 on interface Ethernet 0/0/0. As shown above, the policy routing
has one 0 node and includes an if-match clause and an apply clause. For
the accurate meanings of the if-match clause and the apply clause,
refer to the description on the command.
The output of the display ip policy setup local command is the same as
that of the display ip policy setup interface command, except that it
displays the policy routing enabled on this router but not the
configuration of the specified route-policy.
View This command can be used in the following views:
■ Any view