Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display ip multicast-policy ● 147
Command Reference
display ip multicast-policy
Purpose Use the display ip multicast-policy command to view the multicast policy
routing information.
Syntax display ip multicast-policy [ setup interface interface-type
interface-num | statistic interface interface-type interface-num ]
Parameters interface-type
interface-num
Specifies an interface by its type and number.
Example Display the information about the multicast policy routing configured on interface
Ethernet2/0/0.
[3Com] display ip multicast-policy setup interface ethernet2/0/0
route-policy cc permit node 10
if-match acl 3110
apply ip-address next-hop acl 2050
route-policy cc permit node 20
if-match acl 3120
apply output-interface acl 1005
Display the statistic information about the multicast policy routing configured on
interface Ethernet2/0/0.
[3Com] display ip multicast-policy statistic interface ethernet2/0/0
interface Ethernet2/0/0 multicast-policy routing summary information:
Total packets matched: 5
Total packets forward : 20
View This command can be used in the following views:
■ Any view