Command Reference Guide

142 ● display ip interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
display ip interface
Purpose Use the display ip interface command to view IP-related information about
the specified or all interfaces.
Syntax display ip interface [ interface-type interface-number ]
Parameters interface-type
Interface type.
interface-number
Interface number.
Default By default, if no interface is specified, the IP-related information about all interfaces is
displayed.
Example Display IP-related information about interface Serial 1/0/0.
<3Com> display ip interface serial 1/0/0
Serial1/0/0 current state :UP
Line protocol current state :DOWN
Internet Address is 1.1.1.2/24
Broadcast address : 1.1.1.255
The Maximum Transmit Unit : 1500 bytes
ip fast-forwarding incoming packets state is Enabled
ip fast-forwarding outgoing packets state is Enabled
IP input packets : 0, bytes : 0, multicasts : 0
IP output packets : 0, bytes : 0, multicasts : 0
TTL invalid packet number: 0
ICMP packet input number: 0
Echo reply: 0
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
DHCP packet deal mode: global
View This command can be used in the following views:
■ Any view