Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display configure-user ● 89
Command Reference
display configure-user
Purpose Use the display configure-user command to view information about the user
who is currently authorized to configure the equipment.
Syntax display configure-user
Parameters None
Example Display information about the user who is currently authorized to configure the
equipment.
<3Com> display configure-user
If the adopted authentication does not require a username, the actual
display shall be:
The information of current configuration user:
UI Delay Type Ipaddress Username
34 VTY 0 00:00:04 TEL [phone]
If the login authentication otherwise requires a username, the actual
display shall be:
The information of current configuration user:
UI Delay Type Ipaddress Username
34 VTY 0 00:00:05 TEL [phone] test
View This command can be used in the following views:
■ Any view
Description Users can configure the same equipment through the Console port, the AUX port,
the VTY interface (in cases such as Telnet and SSH) and others. If configurations by
these various means are permitted to be conducted simultaneously, the configuration
of one user is liable to overwrite others’ configuration. For this reason, the VRP
requires that only one user should have right to modify configurations of the
equipment at a time. In other words, once a user is performing configurations on the
equipment, other users, including those with higher priorities, are not permitted to
configure the equipment at that very moment, but rather wait till the user currently
conducting the configurations quitting or timed out of the system.