Command Reference Guide

72 ● dhcp server bims-server interface (System view) 3Com Router 5000 Family and Router 6000 Family
Command Reference
dhcp server bims-server interface (System
view)
Purpose Use the dhcp server bims-server interface command to enable and
configure BIMS option support for an interface or all interfaces configured with
interface address pools.
Use the undo dhcp server bims-server command to disable BIMS option
support for an interface or all interfaces configured with interface address pools.
Syntax dhcp server bims-server ip ip-address [ port port-number ] sharekey key
{ interface interface-type interface-number [ to interface-type
interface-number ] | all }
undo dhcp server bims-server { interface interface-type
interface-number [ to interface-type interface-number ] | all }
Parameters ip ip-address
IP address of the BIMS server.
port port-number
Number of the protocol port on the BIMS server. Valid
values are 1 to 65534.
sharekey key
Shared key of the BIMS server, which can be 1 to 16
characters in length.
interface-type
interface-number [ to
interface-type
interface-number ]
Indicates an interface or all interfaces from the first
specified interface to the second. Note that the
interfaces must be Ethernet interfaces (or
subinterfaces) or virtual Ethernet interfaces.
all
Indicates all interfaces configured with interface
address pools.
Default By default, BIMS option support is not configured on the DHCP server.
Example Configure BIMS option support on Ethernet interface ethernet0/0/0 (which is
configured with an interface address pool), setting the IP address of the BIMS server
to 192.168.1.1, the protocol port to 80, and the shared key to abcdefg.
[3Com] dhcp server bims-server ip 192.168.1.1 port 80 sharekey abcdefg
interface ethernet0/0/0
View This command can be used in the following views:
■ System view