Command Reference Guide

3Com Router 5000 Family and Router 6000 Family debugging ip multicast-policy ● 51
Command Reference
debugging ip multicast-policy
Purpose Use the debugging ip multicast-policy command to enable the debugging
of IP multicast policy routing.
Use the undo debugging ip multicast-policy command to disable the
debugging of multicast policy routing.
Syntax debugging ip multicast-policy [ acl-number ]
undo debugging ip multicast-policy
Parameters acl-number
ID of interface-based ACL. Valid values are 1000 to
1999.
Example None
View This command can be used in the following views:
■ User view
Description The contents of the debugging information contain the route-node that the packets
match and the next hop/outgoing interface to which the packets are forwarded. The
debugging information output can be filtered with the interface-based ACL.
It should be noted that enabling the debugging would affect the performance of the
system. You should disable the debugging when the system is running normally.
Related Command route-policy