Command Reference Guide

3Com Router 5000 Family and Router 6000 Family apply output-interface (for Unicast Policy Routing) ● 17
Command Reference
apply output-interface (for Unicast Policy
Routing)
Purpose Use the apply output-interface command to set a packet forwarding
interface.
Use the undo apply output-interface command to cancel the configuration
on a forwarding interface.
Syntax apply output-interface interface-type interface-number [ interface-type
interface-number ]
undo apply output-interface [ interface-type interface-number [
interface-type interface-number ] ]
Parameters interface-type
Interface type.
interface-number
Interface number.
Example Specify forwarding interface as serial0/0/0 for the matched IP packet.
[3Com-route-policy] apply output-interface Serial 0/0/0
View This command can be used in the following views:
■ Route-Policy view
Description This command is used to set the packet forwarding interface for the matched IP
packet. At most two forwarding interfaces can be specified.
Related Commands ■ apply ip-precedence
■ apply ip-address next-hop (for Unicast Policy Routing)
■ apply default output-interface
■ apply ip-address next-hop (for Unicast Policy Routing)