Command Reference Guide

16 ● apply output-interface (for Multicast Policy Routing) 3Com Router 5000 Family and Router 6000 Family
Command Reference
apply output-interface (for Multicast Policy
Routing)
Purpose Use the apply output-interface command to configure an outgoing interface
list in a route-node.
Use the undo apply output-interface command to remove the
configuration.
Syntax apply output-interface acl acl-number
undo apply output-interface [ acl acl-number ]
Parameters acl-number
ID of interface-based ACL. Valid values are 1000 to
1999.
Default By default, no apply clause is defined.
Example None
View This command can be used in the following views:
■ Route-Policy view
Description This command specifies outgoing interfaces for packets that match the if-match
command. It specifies outgoing interfaces for multicast policy routing through the
ACL. The action executed to packets that meet the if-match conditions defined by the
match clause is as follows: If outgoing forwarding interfaces are set in the route-node
through the ACL, the packets will be replicated and forwarded to all interfaces
specified by the ACL.
For an outgoing interface, the specified ACL is the one based on interface.
This command is in juxtaposition relation with the apply ip-address next-hop
command. If both apply clauses are configured at the same time, in multicast policy
routing, the packets will be replicated and forwarded to all the interfaces and next
hops specified by the ACLs respectively. This is different from that only one apply
clause works in unicast policy routing.
Related Commands ■ apply ip-address next-hop (for Multicast Policy Routing)
■ if-match acl
■ display ip multicast-policy