Command Reference Guide

14 ● apply ip-precedence 3Com Router 5000 Family and Router 6000 Family
Command Reference
apply ip-precedence
Purpose Use the apply ip-precedence command to set precedence of IP packets.
Use the undo apply ip-precedence command to remove the precedence of IP
packets.
Syntax apply ip-precedence value
undo apply ip-precedence
Parameters value
The preference value. There are totally 8 (valid values
are 0 to 7) preferences:
■ 0 routine
■ 1 priority
■ 2 immediate
■ 3 flash
■ 4 flash-override
■ 5 critical
■ 6 internet
■ 7 network
Example Set the preference of IP packet to 5 (critical).
[3Com-route-policy] apply ip-precedence critical
View This command can be used in the following views:
■ Route-Policy view
Description This command is used to configure the set clause of route-policy and the preference
for the matched IP packets.
Related Commands ■ apply output-interface (for Unicast Policy Routing)
■ apply ip-address next-hop (for Unicast Policy Routing)
■ apply default output-interface
■ apply ip-address default next-hop