Command Reference Guide

12 ● apply ip-address next-hop (for Unicast Policy Routing) 3Com Router 5000 Family and Router 6000 Family
Command Reference
apply ip-address next-hop (for Unicast Policy
Routing)
Purpose Use the apply ip-address next-hop command to set the packet next hop.
Use the undo apply ip-address next-hop command to cancel the
configuration about the next hop.
Syntax apply ip-address next-hop ip-address [ ip-address ]
undo apply ip-address next-hop [ ip-address [ ip-address ] ]
Parameters ip-address
IP address of next hop.
Example Set the packet next hop to 1.1.1.1.
[3Com-route-policy] apply ip-address next-hop 1.1.1.1
View This command can be used in the following views:
■ Route-Policy view
Description This command is used to set the next hop for the matched IP packet and at most two
next hops can be specified. The next hop should be adjacent to this device.
Related Commands ■ apply ip-precedence
■ apply output-interface (for Unicast Policy Routing)
■ apply default output-interface
■ apply ip-address default next-hop