Command Reference Guide

3Com Router 5000 Family and Router 6000 Family apply ip-address next-hop (for Multicast Policy Routing) ● 11
Command Reference
apply ip-address next-hop
(for Multicast Policy Routing)
Purpose Use the apply ip-address command to configure the next hop IP address list in a
route-node.
Use the undo apply ip-address command to remove the configuration.
Syntax apply ip-address next-hop { acl acl-number | ip-address [ ip-address ]
}
undo apply ip-address next-hop [ acl acl-number | ip-address [
ip-address ] ]
Parameters acl-number
Standard ACL number. Valid values are 2000 to 2999.
ip-address
Specifies the next hop address. Multiple next hop
addresses can be specified.
Default By default, no apply clause is defined.
Example None
View This command can be used in the following views:
■ Route-Policy view
Description This command specifies the next hop address for packets that match the if-match
acl command. It specifies the next hop IP address list for multicast policy routing
through the ACL. This command is in juxtaposition relation with the apply
output-interface command. If both apply clauses are configured at the same
time, in multicast policy routing, the packets will be replicated and forwarded to all
the interfaces and next hops specified by the ACLs respectively. This is different from
that only one apply clause works in unicast policy routing.
For the next hop IP address, the specified ACL is the standard ACL.
Related Commands ■ if-match acl
■ apply output-interface (for Multicast Policy Routing)
■ display ip multicast-policy