Command Reference Guide

3Com Router 5000 Family and Router 6000 Family apply ip-address default next-hop ● 9
Command Reference
apply ip-address default next-hop
Purpose Use the apply ip-address default next-hop command to set the default
next hop of a packet.
Use the undo apply ip-address default next-hop command to cancel the
configured default packet next hop.
Syntax apply ip-address default next-hop ip-address [ ip address ]
undo apply ip-address default next-hop [ ip-address [ ip address ] ]
Parameters ip-address
IP address of default next hop.
Example Set the default next hop of a packet to 1.1.1.1.
[3Com-route-policy] apply ip-address default next-hop 1.1.1.1
View This command can be used in the following views:
■ Route-Policy view
Description This command is only valid for the packet whose route has not been found.
Use this command to set the next hop where the matched IP packets are to be
forwarded. You can set at most two next hop interfaces.
Related Commands ■ apply ip-precedence
■ apply output-interface (for Unicast Policy Routing)
■ apply default output-interface
■ apply ip-address next-hop (for Unicast Policy Routing)