Command Reference Guide

8 ● apply default output-interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
apply default output-interface
Purpose Use the apply default output-interface command to set default
forwarding interface for packets.
Use the undo apply default output-interface command to cancel the
configuration of the default forwarding interface of packets.
Syntax apply default output-interface interface-type interface-number [
interface-type interface-number ]
undo apply default output-interface [ interface-type interface-number [
interface-type interface-number ] ]
Parameters interface-type
Interface type.
interface-number
Interface number.
Example Set the default forwarding interface of packets as serial 0/0/0.
[3Com-route-policy] apply default output-interface serial 0/0/0
View This command can be used in the following views:
■ Route-Policy view
Description This command is used to set forwarding interface for the matched IP packet, and the
clause is valid for the packet whose route has not been found.
Use this command to set the next hop where the matched IP packets are to be
forwarded. You can set at most two next hop interfaces.
Related Commands ■ apply ip-precedence
■ apply ip-address next-hop (for Unicast Policy Routing)
■ apply output-interface (for Unicast Policy Routing)
■ apply ip-address default next-hop