Command Reference Guide

76 ● destination-port 3Com Router 5000 Family and Router 6000 Family
Command Reference
destination-port
Purpose Use the destination-port command to configure the destination port in the
test.
Use the undo destination-port command to delete the configured destination
port.
Syntax destination-port port-number
undo destination-port
Parameters port-number
Destination port number in a test. Valid values are 1 to
65535.
If not values is specified, the default is 0.
Default By default, no destination port is configured for any test.
Example Set the destination port to 9000 in the test.
[Router-administrator-icmp] destination-port 9000
View This command can be used in the following views:
■ HWPing Test Group view
Description This command is configured only for DHCP, DLSw, FTP, HTTP, jitter, TCP-private, or
UDP-private test.
Related Command destination-ip