Command Reference Guide

364 ● x25 xot pvc 3Com Router 5000 Family and Router 6000 Family
Command Reference
x25 xot pvc
Purpose Use the x25 xot pvc command to add a PVC route of XOT. Use the undo x25
pvc
command to delete the specified PVC route of XOT.
Syntax x25 xot pvc pvc-number1 ip-address interface type number pvc
pvc-number2 [ xot-option ] [ packet-size input-packet output-packet
window-size input-window-size output-window-size ]
undo x25 pvc pvc-number1
Parameters pvc-number1
Number of PVC on the local interface. Valid values are
1 to 4095.
pvc-number2
Number of PVC on the peer interface. Valid values are
1 to 4095.
ip-address
IP address of the peer destination for connection with
XOT.
interface type number
Type and number of remote X.25 interface, and the
interface type can only be Serial.
xot-option
XOT channel parameter option. see the following
table.
packet-size input-packet
output-packet
Specifies the maximum receiving packet length and
maximum sending packet length. The length is
counted in bytes, which must range from 16 to 4096
(including 16 and 4096), and must be the integer
power of 2.
window-size
input-window-size
output-window-size
Specifies the receiving window and sending window
sizes of the VC, which range between 1 and the
number that is 1 less than the modulus of the X.25
interface where the address mapping exists (including
1 and modulus minus 1).
Default By default, no PVC route is configured.
Table 1 XOT channel parameter option
Option Description
timer seconds Keepalive timer delay of XOT connection. The timer sends the
keepalive packet upon timeout to detect the connection availability.
Valid values are 1 to 3600.
retry times Number of maximum retries of sending keepalive. If the number
exceeds times, the XOT connection will be disconnected. Valid
values are 3 to 3600.
source
interface-type
interface-number
Type and number of the interface that initiates the XOT connection.