Command Reference Guide

358 ● x25 timer tx3 3Com Router 5000 Family and Router 6000 Family
Command Reference
x25 timer tx3
Purpose Use the x25 timer tx3 command to set clearing request (indication) transmission
timer delay for DTE (or DCE).
Use the undo x25 timer tx3 command to restore its default value.
Syntax x25 timer tx3 seconds
undo x25 timer tx3
Parameters seconds
Delay time of clearing request (indication) transmission
timer (in seconds). Valid values are 0 to 1000.
By default, the delay time on a DTE clearing timer is
180 seconds; the default on a DCE clearing timer is 60
seconds.
Example Set the delay time of clearing timer on the X.25 interface Serial0/0/0 to 100 seconds.
[3Com-Serial0/0/0] x25 timer tx3 100
View This command can be used in the following views:
■ Interface view
Description According to X.25, a timer should be started when a DTE sends a clear request (or a
DCE sends a clear indication). If no peer acknowledgement is received after this timer
is timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay time of this
timer before the timeout.
Related Commands ■ x25 timer tx0
■ x25 timer tx1
■ x25 timer tx2