Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 timer tx2 ● 357
Command Reference
x25 timer tx2
Purpose Use the x25 timer tx2 command to set resetting request (indication) transmission
timer delay for DTE (or DCE).
Use the undo x25 timer tx2 command to restore its default value.
Syntax x25 timer tx2 seconds
undo x25 timer tx2
Parameters seconds
Delay time of resetting request (indication) timer (in
seconds). Valid values are 0 to 1000. By default, the
delay time on a DTE reset timer is 180 seconds; that on
a DCE reset timer is 60 seconds.
Example Set the reset timer delay on the X.25 interface Serial0/0/0 to 120 seconds.
[3Com-Serial0/0/0] x25 tx2 120
View This command can be used in the following views:
■ Interface view
Description According to X.25, a timer should be started when a DTE sends a reset request (or a
DCE sends a reset indication). If no peer acknowledgement is received after this timer
is timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay time of this
timer before the timeout.
Related Commands ■ x25 timer tx0
■ x25 timer tx1
■ x25 timer tx3