Command Reference Guide

356 ● x25 timer tx1 3Com Router 5000 Family and Router 6000 Family
Command Reference
x25 timer tx1
Purpose Use the x25 timer tx1 command to set calling request (indication) transmission
timer delay for DTE (or DCE).
Use the undo x25 timer tx1 command to restore its default value.
Syntax x25 timer tx1 seconds
undo x25 timer tx1
Parameters seconds
Delay time of calling request (indication) transmission
timer (in seconds). Valid values are 0 to 1000. By
default, the delay time on a DTE call timer is 200
seconds; that on a DCE call sending timer is 180
seconds.
Example Set the timer delay on the X.25 interface Serial0/0/0 to 100 seconds.
[3Com-Serial0/0/0] x25 tx1 100
View This command can be used in the following views:
■ Interface view
Description According to X.25, a timer should be started when a DTE sends a call request (or a
DCE sends a call indication). If no peer acknowledgement is received after this timer is
timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay time of this
timer before the timeout.
Related Commands ■ x25 timer tx0
■ x25 timer tx2
■ x25 timer tx3