Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 timer tx0 355
Command Reference
x25 timer tx0
Purpose Use the x25 timer tx0 command to set the restart/retransmission timer delay for
DTE (or DCE).
Use the undo x25 timer tx0 command to restore their default values.
Syntax x25 timer tx0 seconds
undo x25 timer tx0
Parameters seconds
Delay time for the X.25 restarting timer (in seconds).
Valid values are 0 to 1000. By default, the delay on the
X.25 DTE restarting timer is 180 seconds and that on
the DCE timer is 60 seconds.
Example Set the restarting timer delay on the X.25 interface Serial0/0/0 to 120 seconds.
[3Com-Serial0/0/0] x25 timer tx0 120
View This command can be used in the following views:
Interface view
Description According to X.25, a timer should be started when a DTE sends a restart request (or a
DCE sends a restart indication). If no peer acknowledgement is received after this
timer is timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay time of this
timer before the timeout.
Related Commands x25 timer tx1
x25 timer tx2
x25 timer tx3