Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 switch svc hunt-group ● 345
Command Reference
x25 switch svc hunt-group
Purpose Use the x25 switch svc hunt-group command to add an X.25 switching route
whose forwarding address is a hunt group.
Use the undo x25 switch svc hunt-group command to delete the specified
X.25 switching route.
Syntax x25 switch svc x.121-address [ sub-dest destination-address ] [
sub-source source-address ] hunt-group hunt-group-name
undo x25 switch svc x.121-address [ sub-dest destination-address ] [
sub-source source-address ] hunt-group hunt-group-name
Parameters x.121-address
Destination address of X.121. This parameter consists
of mode matching string from 1 to 15 characters long.
See Table 1 and Table 2.
sub-dest
destination-address
Substitution destination address.
sub-source source-address
Substitution source address.
hunt-group-name
Name of hunt group.
Default By default, no X.25 switching route is configured.
Example Add an X.25 switching route, whose destination address is 8888 and forwarding
address is the hunt group hg1, and substitute the destination address with 9999.
[3Com] x25 switch svc 111 sub-dest 9999 sub-source 8888 hunt-group hg1
View This command can be used in the following views:
■ System view
Description After the X.25 switching route whose forwarding address is a hunt group is
configured, the relevant X.25 call request packet will be forwarded to different
interfaces or XOT channels in the specified hunt group, so as to implement the load
sharing under X.25 protocol.
Note that you cannot configure SVCs on X.25 subinterfaces.