Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 switch pvc ● 343
Command Reference
x25 switch pvc
Purpose Use the x25 switch pvc (packet switching) command to configure one PVC
route.
Use the undo x25 switch pvc command to delete one PVC route.
Syntax x25 switch pvc pvc-number1 interface serial number pvc
pvc-number2
[ option
]
undo x25 switch pvc pvc-number1
Parameters pvc-number1
PVC number on the input interface. Valid values are 1
to 4095.
pvc-number2
PVC number on the output interface. Valid values are 1
to 4095.
number
Number of the output interface. It cannot be a
subinterface.
option
Attribute of PVC.
Default By default, no PVC route is defined.
Example Perform the packet switching between PVC1 on the Serial0/0/0 and PVC1 on the
Serial1/0/0.
[3Com-Serial0/0/0] link-protocol x25 dce ietf
[3Com-Serial0/0/0] interface serial1/0/0
[3Com-Serial0/0/0] link-protocol x25 dce ietf
[3Com-Serial1/0/0] x25 switch pvc 1 interface serial 0/0/0 pvc 1
View This command can be used in the following views:
■ Interface view
Description Based on the X.25 switching configuration, you can use the 3Com series Routers as a
simple X.25 switch. When PVC switching is configured, the link layer protocols on the
input and output interfaces must be X.25. Moreover, the specified PVCs on the two
interfaces have been presented and enabled. Note that PVC switching cannot be
configured on the X.25 sub-interface.
Detailed explanations of PVC options are follows:
broadcast: Forwards broadcast packet to the peer PVC.
encapsulation-type: Encapsulation type, which may be nonstandard, ietf,
multi-protocol and snap.