Command Reference Guide
3Com Router 5000 Family and Router 6000 Family x25 reverse-charge-accept ● 341
Command Reference
x25 reverse-charge-accept
Purpose Use the x25 reverse-charge-accept command to enable this interface to
accept the call with “reverse charging request”, the information added by some
certain user facilities.
Use the undo x25 reverse-charge-accept command to disable this above
function.
Syntax x25 reverse-charge-accept
undo x25 reverse-charge-accept
Parameters None
Default By default, this function is disabled.
Example Set the “accepting calls with reverse charging request” function on interface
Serial0/0/0.
[3Com-Serial0/0/0] x25 reverse-charge-accept
View This command can be used in the following views:
■ Interface view
Description This function does not affect any call without “reverse charging request”.
If you enable this function on an X.25 interface, all these calls that reach the interface
will be accepted. If you enable this function for a certain address mapping by the
option reverse-charge-accept in the command x25 map, only such calls that reach the
interface and map this address will be accepted, while other calls (carrying reverse
charging request, and not mapping this address) will be cleared.
Related Command x25 map