Command Reference Guide

340 ● x25 response calling-address 3Com Router 5000 Family and Router 6000 Family
Command Reference
x25 response calling-address
Purpose Use the x25 response calling-address command to enable X.25 to carry
the address information of the calling DTE in sending call reception packet.
Use the undo x25 response calling-address command to disable the
above function.
Syntax x25 response calling-address
undo x25 response calling-address
Parameters None
Default By default, this function is disabled.
Example Specify that the call receiving packet of a call sent from the X.25 interface Serial0/0/0
carries the calling DTE address.
[3Com-Serial0/0/0] x25 response calling-address
View This command can be used in the following views:
■ Interface view
Description According to X.25, the call receiving packet of a call may or may not carry an address
code group, depending on the specific network requirements. This command enables
users to easily specify whether the call receiving packet of a call sent by X.25 of the
3Com series routers carries the calling DTE address.
Related Commands ■ x25 response called-address
■ x25 ignore called-address
■ x25 ignore calling-address