Command Reference Guide

324 ● x25 hunt-group 3Com Router 5000 Family and Router 6000 Family
Command Reference
x25 hunt-group
Purpose Use the x25 hunt-group command to create or enter an X.25 hunt group.
Use the undo x25 hunt-group command to delete the specified X.25 hunt
group.
Syntax x25 hunt-group hunt-group-name { round-robin | vc-number }
undo x25 hunt-group hunt-group-name
Parameters hunt-group-name
Name of hunt group.
round-robin
Select call channel using cyclic selection policy.
vc-number
Select call channel using the policy of computing
available logical channel.
Example Create hunt group hg1 which uses cyclic selection policy.
[3Com] x25 hunt-group hg1 round-robin
[3Com-hg-hg1]
View This command can be used in the following views:
■ System view
Description X.25 hunt group supports two call channel selection policies: round-robin mode and
vc-number mode, and a hunt group only uses one channel selection policy. The
round-robin mode will select next interface or XOT channel inside hunt group for
each call request using cyclic selection method. The vc-number mode will select the
interface with the most idle-logical channels in hunt group for each call request.
A hunt group can have 10 interfaces or XOT channels at most, and it may arbitrarily
select the available channels between interface and XOT channel.
XOT channel cannot join the hunt group that adopts the vc-number selection policy.
Related Command display x25 hunt-group-info