Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 cug-service ● 321
Command Reference
x25 cug-service
Purpose Use the x25 cug-service command to enable CUG service and suppression
policies.
Use the undo x25 cug-service command to disable CUG service.
Syntax x25 cug-service [ incoming-access ] [ outgoing-access ] [ suppress {
all | preferential } ]
undo x25 cug-service
Parameters incoming-access
Performs the suppress processing of incoming access
outgoing-access
Performs the suppress processing of outgoing access
all
Suppresses all CUGs configured with preferential
suppress
preferential
Only processes those CUGs configured with
preferential suppress
Default By default, CUG service is disabled.
Example Define the suppress processing of incoming access on the interface Serial0/0/0.
[3Com-Serial0/0/0] x25 cug-service incoming-access
View This command can be used in the following views:
■ Interface view
Description The command is used at DEC end. You can use the link-protocol x25 dce
command to set the interface operating in DCE mode.
After CUG service is enabled, the system suppresses those calls matching the preset
conditions. The details are:
If no parameter is set, the system suppresses all calls (including the calls with or
without CUG facilities).
If the incoming-access parameter is chosen, the system suppresses incoming calls.
That is, it suppresses the incoming calls with CUG facilities, but lets the incoming calls
without CUG facilities pass through.
If the outgoing-access parameter is chosen, the system suppresses outgoing calls.
That is, it suppresses the outgoing calls with CUG facilities, but lets the outgoing calls
without CUG facilities pass through.