Command Reference Guide

3Com Router 5000 Family and Router 6000 Family timer hold ● 311
Command Reference
timer hold
Purpose Use the timer hold command to set the polling interval.
Use the undo timer hold command to restore the default value of the polling
interval.
Syntax timer hold seconds
undo timer hold
Parameters seconds
Value of the polling interval (in seconds). Valid values
are 0 to 32767. A 0 indicates that the link detection
function is disabled.
Default By default, the value of seconds is 10 seconds.
Example Set the value of polling interval on interface Serial1/0/0 to 100 seconds.
[3Com-Serial1/0/0] timer hold 100
View This command can be used in the following views:
■ Interface view
Description The polling interval should be set to equal at the two ends of the data link. A zero
polling interval set in both ends will close the polling operation of the data link.
Related Command display interface