Command Reference Guide
3Com Router 5000 Family and Router 6000 Family routed-bridge protocol ● 301
Command Reference
routed-bridge protocol
Purpose Use the routed-bridge protocol command to enable the support of routed
bridge encapsulation to a network protocol.
Use the undo routed-bridge protocol command to disable the support of
routed bridge encapsulation to a network protocol.
Syntax routed-bridge protocol protocol-name
undo routed-bridge protocol protocol-name
Parameters protocol protocol-name
Specifies a network protocol, which can be ip or mpls
only.
Example Bind a VE interface with PVC 1/101 to create a routed bridge map entry.
[3Com-atm-pvc-Atm1/0/0.1-1/101] map routed-bridge virtual-ethernet 1
Enable the support of routed bridge encapsulation to IP and MPLS.
[3Com-atm-pvc-Atm1/0/0.1-1/101] routed-bridge protocol ip
[3Com-atm-pvc-Atm1/0/0.1-1/101] routed-bridge protocol mpls
View This command can be used in the following views:
■ ATM PVC view
Description At present the network protocols supported by routed bridge encapsulation are IP
and MPLS only. As IP is used more often than MPLS, the support to it is enabled upon
execution of the
map routed-bridge command.
As IP is the basis of MPLS, you need enable the support of routed bridge
encapsulation to IP when enabling the support of routed bridge encapsulation to
MPLS.