Command Reference Guide

3Com Router 5000 Family and Router 6000 Family pvp limit ● 287
Command Reference
pvp limit
Purpose Use the pvp limit command to set the parameters for VP policing.
Use the undo pvp limit command to delete the VP policing.
Syntax pvp limit vpi peak-rate
undo pvp limit vpi
Parameters vpi
Virtual path identifier of ATM network, its value ranges
from 0 to 255.
peak-rate
Normal flow to be held. Value range of this parameter
depends on interface type, as shown in the following
table:
Default By default, the VP policing is not performed.
Example Set the traffic of VP with vpi 1 to 2M.
[3Com-Atm1/0/0] pvp limit 1 2000
View This command can be used in the following views:
■ ATM Master Interface view
Description When applying VP policing, the parameters of PVC are still valid. Only when the
parameters of PVC and VP policing are satisfied, will the packets be transmitted.
When calculating the traffic, the LLC/SNAP, MUX and NLPID headers are included, but
the ATM cell head is not included.
Related Commands ■ pvc
■ service cbr
■ service vbr-nrt
Table 1 Value ranges of peak-rate
Interface type peak-rate
ADSL <64-640>
GSHDSL <64-2312>
ATMOC3 <2000-155000>
ATM25 <64-25600>
ATME3 <64-34000>
ATMT3 <64-44000>