Command Reference Guide

282 ● pvc-group 3Com Router 5000 Family and Router 6000 Family
Command Reference
pvc-group
Purpose Use the pvc-group command to create a PVC-Group or enter the PVC-Group view
at ATM interface.
Use the undo pvc-group command to delete the specified PVC-Group.
Syntax pvc-group { pvc-name [ vpi/vci ] | vpi/vci }
undo pvc-group { pvc-name [ vpi/vci ] | vpi/vci }
Parameters pvc-name
PVC name, whose maximum length is 16 characters. It
is case insensitive and should be unique at ATM
interface. And it should not be legal VPI/VCI pair. For
example, "1/20" cannot be a PVC name. The PVC
corresponding to
pvc-name must have already been
created.
vpi/vci
vpi is ATM Virtual Path Identifier (VPI) in the range 0 to
255; vci is ATM Virtual Channel Identifier (VCI). For its
value range, refer to Table 7-7. Usually, the vci values
from 0 to 31 are reserved for special usage and cannot
be used. PVC corresponding to
vpi/vci must have
already been created.
Example Display how to create a PVC-Group based on the name "3Com" and the PVC with
VPI/VCI as 1/32.
[3Com-Atm1/0/0] pvc-group 3Com 1/32.
View This command can be used in the following views:
■ ATM Interface view
Description Once pvc-name is specified for some PVC (e.g. "3Com"), it is possible to enter the
PVC-Group view by inputting
pvc-group pvc-name (e.g. "pvc-group 3Com").
The deletion of the PVC-Group can be done by inputting undo pvc-group
pvc-name (e.g. "undo pvc-group 3Com") or through the undo pvc-group
vpi/vci (if the VPI/VCI of this PVC is 1/32, it is " undo pvc-group 1/32")
command.
Related Commands ■ ip-precedence
■ pvc