Command Reference Guide

274 ● pppoe-client 3Com Router 5000 Family and Router 6000 Family
Command Reference
one-to-one. If the Dialer Bundle at a certain Dialer has had one Ethernet interface
used by PPPoE, any other interfaces cannot be added to this Dialer Bundle. Likewise, if
Dialer Bundle has had interfaces other than the PPPoE Ethernet interface, this Dialer
Bundle can also not be added to the Ethernet interface used by PPPoE Client.
When PPPoE session works in permanent online mode, and the physical lines go UP,
the Router will immediately initiate PPPoE call to establish PPPoE session. This PPPoE
connection will exist constantly unless users use the command
undo
pppoe-client
to delete PPPoE session. When PPPoE session works in packet
trigger mode, the Router will not initiate PPPoE call to establish PPPoE session unless it
has data to transmit. If there is no data transmission on the PPPoE link within
seconds, the Router will automatically terminate PPPoE session. Only after it has
new data to transmit, PPPoE session will be re-established.
Related Command reset pppoe-client