Command Reference Guide

270 ● ppp mp virtual-template 3Com Router 5000 Family and Router 6000 Family
Command Reference
ppp mp virtual-template
Purpose Use the ppp mp virtual-template command to configure the virtual template
number to be bound by the interface.
Use the undo ppp mp command to disable the MP binding of the interface.
Syntax ppp mp virtual-template number
undo ppp mp
Parameters number
Configures the virtual template number to be bound
by the interface. Valid values are 0 to 1023.
Default By default, the MP binding of the interface is disabled, and the interface works in
ordinary PPP mode.
Example Configure the PPP encapsulated interface Serial0/0/0 to work in MP mode.
[3Com-Serial0/0/0] ppp mp virtual-template 1
View This command can be used in the following views:
■ Interface view
Description This command specifies the virtual template number to be bound on the interface.
The interface using this command to perform the MP binding needs not configuring
PAP or CHAP authentication. Two or more interfaces with the same virtual template
number is bound directly together. Moreover, this command is mutually exclusive with
the
ppp mp command. That is, only one of the two commands can be configured on
a same interface.
Related Commands ■ link-protocol ppp
■ interface virtual-template