Command Reference Guide

3Com Router 5000 Family and Router 6000 Family ppp ipcp remote-address forced ● 255
Command Reference
ppp ipcp remote-address forced
Purpose Use the ppp ipcp remote-address forced command to forbid the peer to
use the fix self-configured IP address but the one allocated by this router.
Use the undo ppp ipcp remote-address forced command to cancel the
setting of forcible address allocation, allowing the peer to use its self-configured IP
address.
Syntax ppp ipcp remote-address forced
undo ppp ipcp remote-address forced
Parameters None
Default By default, the peer can use its self-configured IP address in PPP IPCP negotiation. If
the peer explicitly requests this end for an address, this end acts as requested; if the
peer already has a self-configured IP address, this end does not allocate one to the
peer.
Example The PPP-encapsulated interface serial 0/0/0 wants to allocate the IP address 10.0.0.1
to the peer. The peer can accept this allocated address, a self-configured address, or
have no address.
[3Com-Serial0/0/0] remote address 10.0.0.1
The PPP-encapsulated interface serial 0/0/0 wants to allocate the IP address 10.0.0.1
to the peer. The peer must accept this allocated address and cannot use a
self-configured address or have no address.
[3Com-Serial0/0/0] remote address 10.0.0.1
[3Com-Serial0/0/0] ppp ipcp remote-address forced
View This command can be used in the following views:
■ Interface view
Description If the peer is not allowed to use self-configured IP address, you must configure the
ppp ipcp remote-address forced command on the local interface.
Related Command remote address