Command Reference Guide

230 ● mfr link-name 3Com Router 5000 Family and Router 6000 Family
Command Reference
mfr link-name
Purpose Use the mfr link-name command to set the frame relay bundle link identification
(LID).
Use the undo mfr link-name command to restore the default setting.
Syntax mfr link-name [ name ]
undo mfr link-name [ name ]
Parameters name
Name of a bundle link identification. Valid values are a
character string from 1 to 49 characters long.
Default By default, LID is the name of the corresponding physical interface.
Example Set the bundle LID of the multilink frame relay bundle link Serial4/1/2 to be bl1.
[3Com-Serial4/1/2] mfr link-name bl1
View This command can be used in the following views:
■ Frame Relay Interface view
Description The peer equipment identifies a frame relay bundle link via LID or associates the
bundle link with a frame relay bundle by using LID. LID is locally valid; therefore, the
LIDs at both ends of a link can be the same.
When changing the bundle LID on an interface, you must execute the
shutdown/undo shutdown command on the interface to make the new bundle
LID valid.
Related Command mfr bundle-name