Command Reference Guide
3Com Router 5000 Family and Router 6000 Family map routed-bridge ● 225
Command Reference
map routed-bridge
Purpose Use the map routed-bridge command to configure routed bridge encapsulation
on the PVC.
Use the undo map routed-bridge command to remove routed bridge
encapsulation on the PVC.
Syntax map routed-bridge virtual-ethernet interface-number
undo map routed-bridge
Parameters virtual-ethernet
interface-number
The bound VE interface in a routed bridge map entry.
Example Create a point-to-point ATM subinterface and on it create PVC 1/101.
[3Com] interface atm 1/0/0.1 p2p
[3Com-Atm1/0/0.1] pvc 1/101
Bind a VE interface with PVC 1/101 to create a routed bridge map entry.
[3Com-atm-pvc-Atm1/0/0.1-1/101] map routed-bridge virtual-ethernet 1
View This command can be used in the following views:
■ ATM PVC view
Description Upon execution of the map routed-bridge command, the support of routed
bridge encapsulation to IP is enabled by default.
When using the map routed-bridge command, it can be configured only on
point-to-point PVCs. The bound VE interface must be an idle interface not used by
any other service.