Setup guide

You can select different questions or change your answers on the SpareKey page under Credential
Manager.
After your SpareKey is set up, you can access your computer using your SpareKey from a pre-boot
logon screen or the Windows Welcome screen.
Enrolling your fingerprints
If the administrator selected Fingerprints on the Choose your credentials screen and if your
computer has a fingerprint reader built in or connected, the Getting Started wizard guides you through
the process of setting up, or "enrolling," your fingerprints: You can also enroll your fingerprints on the
Fingerprint page under Credential Manager in the Security Manager dashboard.
1. On the Fingerprints page of the wizard, an outline of two hands is displayed. Fingers that are
already enrolled are highlighted in green. Click a finger on the outline.
NOTE: To delete a previously enrolled fingerprint, click its finger.
2. You are prompted to swipe the finger until its fingerprint is successfully enrolled. An enrolled
finger is highlighted in green on the outline.
3. You must enroll at least two fingers; index or middle fingers are preferable. Repeat steps 1 and 2
for another finger.
4. Click Save, and then follow the instructions on the screen.
CAUTION: When enrolling fingerprints through the wizard, fingerprint information is not saved until
you click Save. If you leave the computer inactive for a while, or close the program, the changes you
made are not saved.
Enrolling scenes for face logon
If your computer has a webcam built in or connected, HP ProtectTools Security Manager prompts you
to set up or “enroll” your scenes during initial setup in the Getting Started Wizard. You can also enroll
scenes on the Face logon page under Credential Manager in the Security Manager dashboard.
You must enroll one or more scenes in order to use face logon. After you have enrolled successfully,
you can also enroll a new scene if you have experienced difficulty during logon because one or more
of the following conditions have changed:
● Your face has changed significantly since your last enrollment.
● The lighting is quite different from any of your previous enrollments.
●
You were wearing glasses (or not) during your last enrollment.
NOTE: If you are having difficulty enrolling scenes, try moving closer to the webcam.
To enroll a scene from the Getting Started Wizard:
1. On the Face logon page of the wizard, click Advanced, and then configure additional options.
For more information, see
Advanced User Settings on page 46.
2. Click OK.
3. Click Start, or if you have enrolled scenes previously, click Enroll a new scene.
44 Chapter 5 HP ProtectTools Security Manager