User's Manual

Table 20 Error messages (continued)
How to correctMeaningStatus code value
In the following cases, the message can occur
because the operation is not allowed when the
The supplied handle is invalid. This can indicate a
user error, program error, or a storage cell in an
uninitialized state.
In the following cases, the storage cell is in an
uninitialized state, but no action is required:
12
Invalid Parameter handle
storage cell is in an uninitialized state. If you
see these messages, initialize the storage cell
and retry the operation.
Storage cell set device addition policy
Storage cell discard (informational message):
Storage cell set name
Storage cell look up object count (informational
message): Storage cell set time
Storage cell look up object (informational message): Storage cell set volume replacement delay
Storage cell free command lock
Storage cell set console lun id
Report the error to product support.The supplied identifier is invalid. This can indicate a
user or program error.
13
Invalid Parameter Id
Report the error to product support.Quorum disks from multiple storage systems are
present.
14
Invalid Quorum
Configuration
Case 1: Report the error to product support.
Case 2: To add additional capacity to the disk
group, use the management software to add
disks by count or capacity.
The supplied target handle is invalid. This can indicate
a user or program error (Case 1),
or
Volume set requested usage (Case 2):
15
Invalid Target Handle
The operation could not be completed because the
disk has never belonged to a disk group and therefore
cannot be added to a disk group.
Report the error to product support.The supplied target identifier is invalid. This can
indicate a user or program error.
16
Invalid Target Id
Report the error to product support.The time value specified is invalid. This can indicate
a user or program error.
17
Invalid Time
Report the error to product support.The operation could not be completed because one
or more of the disk media was inaccessible.
18
Media is Inaccessible
Report the error to product support.The Fibre Channel port specified is not valid. This can
indicate a user or program error.
19
No Fibre Channel Port
Report the error to product support.There is no firmware image stored for the specified
image number.
20
No Image
The disk device must be in either maintenance
mode or in a reserved state for the specified
operation to proceed.
The disk device is not in a state to allow the specified
operation.
21
No Permission
Create a storage cell and retry the operation.The operation requires a storage cell to exist.22
Storage system not
initialized
Report the error to product support.The Fibre Channel port specified is either not a loop
port or is invalid. This can indicate a user or program
error.
23
Not a Loop Port
Verify that the controller is a participating
member of the storage cell.
The controller must be participating in the storage cell
to perform the operation.
24
Not a Participating
Controller
Case 1: Either delete the associated object or
resolve the in progress state.
Case 2: . Report the error to product support.
Several states can cause this message:
Case 1: The operation cannot be performed because
an association exists a related object, or the object
is in a progress state.
25
Objects in your system
are in use, and their state
prevents the operation
you wish to perform.
Case 3: Unpresent the LUNs before deleting
this virtual disk.
98 Error messages