User's Manual

Table 4 (page 16) describes the port LED indicators for the management module Ethernet port
(callouts 3 and 4 in Figure 11 (page 15) and Figure 12 (page 15)).
Table 4 Management module Ethernet port LED indicators
StatusLED stateLED functionLocationLED color
No link detected.OffLink state indicatorLeftGreen
Link detected.Solid green
No activity.OffLink activity indicatorRightAmber
Normal activity.Blinking amber
Controller status indicators
The status indicators display the operational status of the controller. The function of each indicator
is described in Table 8 (page 17). During initial setup, the status indicators might not be fully
operational.
Each port on the rear of the controller has an associated status indicator located directly above it.
Table 5 (page 16) lists the port and its status description for the HSV300. Table 6 (page 16) lists
the port and its status descriptions for the HSV300–S.
Table 5 HSV300 controller port status indicators
DescriptionPort
Fibre Channel host ports
• Green—Normal operation
• Amber—No signal detected
• Off—No SFP
1
detected or the Direct Connect HP P6000 Control Panel setting
is incorrect
Fibre Channel device ports
• Green—Normal operation
• Amber—No signal detected or the controller has failed the port
• Off—No SFP
1
detected
• Flashing green–Link recovery in progress (the link has been detected as down
or failed and attempts to re-initialize the link are in progress)
1
On copper Fibre Channel cables, the SFP is integrated into the cable connector.
Table 6 HSV300-S controller port status indicators
DescriptionPort
Fibre Channel switch ports
• Green on—Normal operation or loopback port
• Green flashing—Normal online I/O activity
• Amber on—Faulted port, disabled due to diagnostics or Portdisable
command
• Amber flashing—Port with no synchronization, receiving light but not yet online
or segmented port
• Off—No SFP
1
, no cable, no license detected
Fibre Channel device ports
• Green—Normal operation
• Amber—No signal detected or the controller has failed the port
• Off—No SFP
1
detected
The HSV300-S controller includes an Ethernet port for the embedded switch (callout 15 in
Figure 12 (page 15)). Table 7 (page 17) describes the LED functions of the Ethernet port.
16 EVA4400 hardware