Technical data

2
-
1
Chapter 2
HARDWARE INSTALLATION
2.1 Hardware Configurations Supported
The software has been tested on and currently supports the
following PCI based system:
• HP Alpha Workstation XP 1000
• HP Alpha Workstation DS10 & DS25
• HP Alpha Workstation 433au
Other similar PCI workstations are expected to work as well.
Please email [e-mail] if you run into any issues.
The following Tech Source cards are supported:
• Raptor 1000 [8-bit, MOX16, MOX24 modes]
• Raptor 2000 [8-bit, MOX16, MOX24 modes]
• Raptor GFX-8PD [8 and 8+24 and 24-bit modes]
• Raptor 1100T [8-bit, MOX16, MOX24, MOX32, 8+8,
8+24, 24-bit modes]
• Raptor 2100T [8-bit, MOX16, MOX24, MOX32, 8+8,
8+24, 24-bit modes]
• Raptor 2500T-DL [8-bit, MOX16, MOX24, MOX32, 8+8,
8+24, 24-bit modes]
The various modes are discussed in detail in Chapter 4.
2.2 Installation Instructions
The Raptor card installation is simple and consists of a few easy
steps. These installation instructions presume that you are
familiar with the HP Tru64 UNIX operating system.