Setup guide

Troubleshooting
3–8
Installation and Setup Guide
Table 3-1: System Troubleshooting,
continued
Problem Possible Cause Action
Security mode is enabled.
Password does not work.
User does not have correct
password.
For Windows NT users, perform the
following steps:
1. Power off the system.
2. Open the system box.
3. Power on the system and wait for
the console to start.
4. Press the password reset button on
the MLB.
5. Power off the system.
6. Reassemble system.
7. Power on the system.
8. Set new password if desired.
NOTE: Take care to remember your
password.
Get necessary configuration data from
the equipment log where you recorded
it.
If you are a DIGITAL UNIX or Open
VMS user, consult Chapter 4 for
instructions on contacting DIGITAL
Customer Support.