Setup guide

Getting Started
1–6
Installation and Setup Guide
The internal network cables are already installed for you.
Optional network kits are available. Contact your DIGITAL
representative for more information about the availability of
these options.
Connecting External System Devices
The following section describes how to install external devices into your system.
1. Connect the microphone and headphones into
the icon-keyed connectors on the side of the
system box, as shown.
2. If a SCSI controller is installed and you have an
optional external SCSI (Small Computer
System Interface) device or SCSI storage box,
connect the SCSI cable to the SCSI port on the
controller card.
If you purchased speakers for your workstation, refer to the figure and perform the
following steps to connect them:
1. Unpack the speakers.
2. Plug the secondary speaker cable into the primary speaker (“Speaker Output”).
3. Connect the loose cable to the primary speaker (“Audio Input”) and to the top
connector on the adapter card (“Speaker Out”).