Owner`s manual

D. Check to see that all of the cables
are connected firmly in their proper
place. See Figure 8.
E. While being sure not to pinch
any cables, use a Philips head
screwdriver to secure the seven
screws 8-16 x .50” (#14) that hold
the console assembly (#2) to the
console back (#4). See Figure 9.
F. Using a Philips head screwdriver
secure the two screws (#13)
securing the console assembly (#2)
to the upright assembly (#3). See
Figure 9.
G. Using a Philips head screwdriver
secure the two screws (#14)
securing the console back cover
(#5) to the console front (#4). See
Figure 10.
9. Attach the motor cover (three
pieces).
A. Using a Phillips head screwdriver,
partially tighten each motor cover
side (left and right) with four
screws, 10-32 x .75” (#16). See
Figure 10.
B. Place the motor cover center (#6)
into position. See Figure 11.
C. Using a Phillips head screwdriver, finish tightening all four screws. Be sure the screws
are securing the motor cover’s tabs.
Cybex 425T Treadmill Owner’s Manual
#16
#6
#8
#16
#7
Figure 9
Console
Assembly
Back
Cover
Screws
Figure 10
Screws
Machine Screw
Console
Assembly
Upright
Assembly
Console
Back
Setup
and
Assembly
Page 5-8
Figure 11