Owner`s manual

Cybex 425T Treadmill Owner’s Manual
Operation
Page 3-5
Press Pause/Stop a second time to interrupt workout data from cycling and to change the
display to Dormant Mode.
The function of the immobilization method: The purpose
of immobilizing the treadmill is to prevent unauthorized use.
This can be accomplished by removing the e-stop key from
the console, unclipping it from the cord and putting it in a
non-accessible place. See Figure 2.
The emergency dismount: Follow the steps listed below
if you experience pain, feel faint or need to stop your
treadmill in an emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key
functions as the emergency stop. In an emergency
situation, remove the e-stop key from the console and
the treadmill will come to a stop. See Figure 3.
Control During Operation
Control keys on the display are usable during operation and may be pressed at any time to
make adjustments in speed, elevation or data readouts.
Changing Speed — Press the Speed
+ — keys to change the speed in increments of 0.1
mph or 0.10 kph. Minimum to maximum speed is from 0.5 - 11.0 mph (0.8 - 17.6 kph).
Changing Incline — Press the Incline keys to change the elevation in increments of
1%. Elevation ranges from 0 to 15%. Press either arrow key once to see the current incline
setting, press multiple times to change incline setting. NOTE: Elevation is defined as the ratio
of rise or fall over run of the treadmill deck.
Workout Time — You can workout up to the maximum time by pressing Quick Start.
Changing Data Readouts — Default setting is for scan to start automatically. Press Scan to
stop and display a set of data. Press Scan once again and it will continually review each set
of data. The display shows each set of data for 3 seconds before switching to the next set.
Figure 3
Figure 2