Owner's manual

3. To help identify the correct enclosure, click Locate > Locate On to display Locate Confirmed

on the controller operator control p anel (OCP). The blue Unit ID indicator will a lso turn on.

• Check the power supply status indicator. See Figure 44.Itshouldbeamberoroff.

Figure 44 Power supp ly status indicator

1. Status i

ndicator

2. Power su

pply 0

3. P ower supply 1

Removing

a power supply

1. Disconnect the AC power cord from the power supply.

2. While moving the wine-colored latch to the left (1, Removing a power supply) , grasp the handle and

pull the power supply out of the enclosure (2).

0139

Figure 45 Removing a power supply

Installing a power supply

1. Rem

ove any connector protector that may be covering the AC power connector on the new power

supply.

2. While pressing in on the mounting latch (1, Installing a power supply), slide the power supply into

the enclosure until it is fully seated (2).

3. Co

nnect the AC power cord to the power supply.

4000/6000/8000 Enterprise Virtual Array user guide