Owner's manual

• Removing password protection (see Clearing a password ).
Changing a pass
word
For security reasons, you may need to change a storage system password. Your password must contain
eight characters consisting of any combination of the uppercase letters A through Z and the lowercase
letters a through z.
Use the following procedure to change the password.
NOTE:
Changing a sys
tem password on the controller requires changing the password on any HP Command
View EVA with access to the storage system.
1. Select a unique, eight-character p assword.
2. From the default menus (Storage System Name or World Wide Name) displayed, press
three
times to display System P assword.
3. Press
to display Change Password?
4. Press Enter for yes.
The default password, AAAA AAAA,isdisplayed.
5. Press
or to select the first character.
6. Press
to accept this character and select the next character.
7. Repeat the process to enter the remaining password characters.
8. Press Enter to enter the password and return to the default display.
Clearing a passwor d
Use the following procedure to remove storage system password protection.
NOTE:
Changing a system password on the controller requires changing the password on any HP Command
View EVA with access to the storage system.
1. Press four times to scroll to the System Password menu.
2. Press
to display Change Password?.
3. Press
to scroll to Clear Password.
4. Press
to display Clear Password.
5. Press Enter to clear the password.
The Password cleared messagewillbedisplayed.
Setting up a controller pair using the OCP
For information about how to set up a controller pair during initial installation see Setting U p a Controller
Pair Using the OCP.
76
Enterprise Virtual Array hardware components