Owner's manual

Fibre Channel loop switches
The EVA8000 uses four FC loop switc hes (Figure 22) to connect all of the drive enclosures to the
controller pair using FC cables. Each switch acts as a central point of interconnection and establishes a
fault-tolerant physical loop topology.
3
4
4
4
2
4
2
3
1
65 7 8 9 1
0
Figure 22 F
Cloopswitch
1. Handle 2. Bezel snaps
3. Alignm
ent tabs
4. Walk-u
pRS232port
5. SFP status indicator 6. Port Bypassed indicator
7. P OST fa u lt i n d i c at o r
8. Over Temp indicator
9. Power i
ndicator
10. Loop o
perational indicator
Power-on self test (POST)
When you power on the Fibre Channel switch, it performs a Power–on Self Test (POST) to verify that
the switch is functioning properly. During a POST, all of the indicators turn on for approximately two
seconds. Then, turn off all of the indicators, except the power indicator.
If the Port Bypass indicators are blinking at a constant rate and the POST Fault indicator is on, the
switch detected a fault during the POST. In this case, you need to contact your HP authorized service
representative.
Reading the switch indicators
The Fi
bre Channel switch contains both system indicators and por t indicators. The system indicators
indicate the status of the switch, and the port indicators provide status of a specificport.Figure 22 shows
the Fibre Channel switch with the system and port indicators.
Table
18 lists and describes the system indicators.
66
Enterprise Virtual Array hardware components